*fill_circular_holes

Fill flat circular holes on 2D elements.

Syntax

*fill_circular_holes mark_id radius_limit

HyperMesh Tcl Modify

This command is used to fill flat circular holes on 2D elements.

mark_id: The mark of nodes on the holes to be filled. Valid values are 1 and 2.
radius_limit: The radius limit for holes to be filled. If set to a positive value, then all circular flat holes with radii less than this limit are filled. In this case, mark_id can be set to 0 and is ignored. Otherwise, all flat holes containing nodes marked are filled.

To fill the hole containing node 7989:

*createmark nodes 1 7989 
*fill_circular_holes 1 -1.0

To fill the holes with a radius less than 5.0:

*fill_circular_holes 0 5.0

Incorrect usage results in a Tcl error. To detect errors, you can use the catch command:

if { [ catch {command_name...} ] } {
   # Handle error
}

10.0