*CE_ConnectorLineCreate

Creates connector(s) on the lines at the given density or spacing.

Syntax

*CE_ConnectorLineCreate entities markmask density spacing half_spacing_offset offset

HyperMesh Tcl Modify

Creates connector(s) on the lines at the given density or spacing.

entities: Type to specify connector location.; Lines
markmask: Line mark for the line collector.
density: Integer number to split line into number of points. Spacing between points.; = line_length/density
spacing: Float number to split line into number of points with specified distance between points.; = spacing
half_spacing_offset: Create points from an offset (= spacing/2) from the start and end of line.
offset: Create points from an offset (= offset) from the start and end of line.

Create a connector on line number 10 on mark 1 with a spacing of 2 and half_spacing_offset.

*createmark(lines, 1) 10
*CE_ConnectorLineCreate(lines, 1, 0, 2.0, 1, 0)

Only one connector is created for each line at the center of the line and it is displayed as a cylinder.