Node Edit Panel

Location: Geom page

Settings are preserved if you switch between subpanels, but selections of nodes, surfaces, and so on are not.

Associate Subpanel

Use the Associate subpanel to create an association between the selected nodes and a selected piece of geometry. Nodes are projected to the geometry, provided the distance to the selected geometry is within the search tolerance. The tolerance is used to create a search sphere at each of the selected nodes. If the selected geometry is found within that search sphere, the node is projected to the closest point on the geometry. An association is made within the database between the nodes (and corresponding elements) and geometry, so any subsequent selection routines can reference either entity. For example, if creating a boundary condition (such as a force, pressure, or constraint) on the geometry, the boundary condition will be applied to the nodes and or elements upon export.

In Figure 1, the brown elements extend beyond the boundaries of the red surface. The elements are in a plane, but the surface is curved away from the plane.

Figure 1.

All of the nodes were selected to associate to the surface. When a small tolerance is specified, only those nodes close enough to the surface are projected and associated to it. In Figure 2, the five highlighted nodes were associated.

Note: The distortion in the elements where only some of the four nodes are associated to the surface.

Figure 2.

When a larger tolerance is used, all of the elements around the boundary of the surface are distorted as the nodes are projected out of their original plane and onto the surface as shown in Figure 3.

Figure 3.

Move Node Subpanel

Place Node Subpanel

Use the Place Node subpanel to move a single node to a specific location on a destination surface. After selecting the surface, select the node to be placed. Once the node is selected, click the new location for that node on the surface.

Figure 4.

Option	Action
destination surf	Select the surface onto which you wish to place the node.
node to place	Select the desired node, then click the desired location on the selected surface. The node relocates automatically.

Remap Subpanel

Use the Remap subpanel to remap a series of nodes to a selected line list.

Figure 5. Selected Nodes Mapped to the Surface Edge. Selected nodes become evenly distributed across the surface edge.

Option	Action
node list	Select the series of nodes that you wish to remap.
line list	Select the line(s) to which you wish the node list to relocate.

Align Node Subpanel

Use the Align Node subpanel to snap one or more nodes to an imaginary line connecting two other selected nodes. Any number of nodes may be aligned once a line is defined.

Figure 6. Align Nodes. The first image shows the two selected nodes that define an infinite line. The second image shows that any nodes selected will be projected to that line.

Option	Action
1st end: node	Select a node that defines one end of the imaginary line.
2nd end: node	Select a node that defines the other end of the imaginary line. Once both nodes are selected, you are prompted to pick the nodes that you wish to align.
nodes/node	Choose whether to select one or more nodes. When set to nodes, click align after you are finished selecting nodes.
use ratio	Specify a ratio to align nodes. Note: Available when aligning one node at a time.

Command Buttons